Build A Guitar


Playing and learning to play a guitar both require a certain level of commitment and inherent talent, the same holds true for building a usable yet attractive guitar. You will thus need to be relatively adept at doing wood work and also have a great ear for pinpointing several pitches and sounds. However, once you have completed your project to utmost satisfaction, you will unquestionably derive a strong sense of achievement. The proceeding instructions should aid you in carrying out this undertaking, do not expect to necessarily complete your guitar the first day you decide to begin building, it will require a great deal of patience and therefore should not be hastened.

Required Tools

Drill and attachment
Bandsaw or jigsaw
Light sandpaper
Router

Required Materials

Two clamps
Three sheets of wood
Pre-made neck and bridge set
Wood glue
Lacquer or wood stain
No less than a dozen wood braces
Two small blocks of hard wood
Guitar strings

Two light weight pieces of a durable kind of wood measuring 3 by 2 feet. These should be about 1/4 of an inch thick.

Instructions

1)The first thing that you will need to do is create the front and back of the acoustic guitar. This will be carried out by using tracing paper to make the shape of the guitar. Use this tracing paper to create an outline of the shape on each guitar section that will be used on either side. Once the shape has been constructed cut the pieces of wood, for improved symmetry of both front and back you may clamp both sections together and cut using the jigsaw or band saw.

2)Next you will need to create a sound hole for your guitar. This will be placed on the front piece. The smaller the hole the greater the bass or low pitched sounds while the larger the hole the greater the treble or higher pitched sounds. The decision will comedown to on personal preference. To do this utilize a large round drill attachment for more precision.

3)Construct the sides of your guitar. This will require two pieces of wood that are adequately long enough to wrap around the edges of the larger pieces with an excess of 5 inches. You can then shape the wood by hand by placing the sections in very hot boiling water for a few seconds. You may have to re-dip the pieces of wood to get the desired shape. This part of the process will require that you be patient, though quick with your fingers while the wood is still malleable.

4)Affix the two sides with blocks of very durable wood glue. When gluing the sections together you must be sure to let the blocks of glue remain on the inner portions of the guitar where they will be basically invisible. Make certain that they are glued firmly and use your clamps to keep the sections in position while the glue sets.

5)You will then have to glue the body sections to the guitar using the wood glue. Like the creation of the base sections, you will have to allow them time to dry thoroughly before moving on from this point.

6)Once the glue has set you can then sand the guitar body, but lightly.

7)Put a lacquer or stain over the guitar body to give it a nice finish. The stain or lacquer should have its own set directions for staining.

8)You can now put on your neck and bridge these are best purchased pre-made for better accuracy. You will have to cut small grooves in your guitar to allow these to fit properly, utilize a routing tool here. Take measurements while carrying this out for once again, precision. When you are done cutting you can then attach the neck and bridge using the wood glue and let dry.

9)Install your bridge using tiny screws and some glue, this should be attached just below the sound hole.

10)Install your strings as you would when changing strings on any guitar.

11)Test your guitar to see that it plays the notes as you would expect and be alert to pinpointing any possible errors in the overall sound.

Tips and Warnings

The total time to complete this project may take a couple weeks to guarantee that the glue is set.

You can utilize templates to enhance the correctness of the guitar’s shape.

Look on a professionally created guitar to get some fundamental ideas and vital understanding of what your guitar should look like.

The fumes from the glue may be hazardous, therefore it is best that you do this outdoors or in a well ventilated area.

Comments are closed.

Powered by Yahoo! Answers